JavaScript seems to be disabled in your browser.

You must have JavaScript enabled in your browser to utilize the functionality of this website. Click here for instructions on enabling javascript in your browser.

Black Sport Dials - Black Bezel Rings - Glass Lens - White LED Lighting

2-1/16" gauges feature the new "no screw, dial forward" design. 
These enhancements bring the dial forward, eliminate any light showing around the edges of the dial at night, for a cleaner, high-end appearance.



  • High quality gauges made in Orange County, CA USA.
  • High-speed full sweep stepper motor speedometer and tachometer
  • Short sweep electric 2-1/16" gauges (Volts, Oil Pres, Water Temp, Fuel Level) 
  • Electric programmable speedo with one-step easy calibration and 2 Trip meters
  • Fuel level gauge available in 5 different ranges (*see below for more info)
  • White through-the-dial LED lighting for easy viewing at night
  • 3D glowing pointer for easy visibility at night

Why pay $800+ for a comparable Auto Meter Sport-Comp II gauge set?


Set Includes:

  • 3-3/8" Electric Programmable Speedometer, 0-160 MPH
  • 3-3/8" Tachometer, 0-10,000 RPM
  • 2-1/16" Volts, 8-18V  
  • 2-1/16" Oil Pressure, 0-80 PSI with sender
  • 2-1/16" Water Temperature, 120-280F with sender
  • 2-1/16" Fuel Level Empty-Full, 73-10 Ohm Stock '66 Mustang input range (default)
  • The oil pressure and water temp sending units are included.  

NOTE:    The volts gauge does not require a sender.
The tachometer does not require a sender - you get the signal from the coil (-) or other tach signal source (i.e. ECU or Tach output on HEI or ignition box).


Through-Dial LED Lighting
This set features through-the-dial LED lighting and glowing 3D pointer for a cool look and easy viewing at night.

This set is assembled in Orange County California, USA.  Please allow 2-3 days for your item to be made before it ships.


The Fuel Level Options:
Please select your fuel level option below - defaults to pre 1985 Ford 73-10 Ohm


Speedometer Signal Generator Options:
Please select if you need a signal generator - defaults to NONE

Speedometer will work with any OEM or aftermarket speed sensor or electronic module that meets the following conditions:

  1. Pulse range generated proportional to the vehicle speed
  2. Signal with minimum 3V peak to peak signal - typical for 3-wire hall effect and 2 wire vehicle speed sensor outputs
  3. output of 4,000 to 200,000 pulses per mile (most senders are 16,000 ppm)

If you currently have a mechanical speedometer (cable driven) you will need a hall effect sender.  See the Available Options Below  to add the correct hall effect sender to your order.  The hall effect sender installs on your current transmission cable take off location. The signal from the hall effect sender (12V Square Wave signal) drives the electric speedometer. 

Available Options:

Fuel Level Compatibility:

Speedometer Sender Options: