New for 2015:
Comp II BLACK 1960s Muscle Car Series - GREEN LED
own a Muscle Car, then it deserves Muscle Car Gauges...
be among the first to
own this set!
2-1/16" gauges feature the new "no screw, dial forward" design.
These enhancements bring the dial forward, eliminate any light showing around
the edges of the dial at night, for a cleaner, high-end appearance.
High quality gauges made in Orange County, CA USA. High-speed full sweep stepper motor speedometer and tachometer
Short sweep electric 2-1/16" gauges (Volts, Oil Pres, Water
Temp, Fuel Level)
Electric programmable speedo with one-step easy calibration and 2 Trip
Fuel level gauge available in 5 different ranges (*see below for more
White through-the-dial LED lighting for easy viewing at night
3D glowing pointer for easy visibility at night
You can't even get a comparable Auto Meter Sport-Comp II gauge set
because they don't make 'em like this!
NOTE: The volts gauge does not require a sender.
The tachometer does not require a sender - you get the signal
from the coil (-) or other tach signal source (i.e. ECU or Tach output on HEI or
This set features through-the-dial LED lighting and glowing 3D pointer for a
cool look and easy viewing at night.
This set is assembled in Orange County California, USA. Please allow 2-3 days
for your item to be made before it ships.
You decide how to wrap up those 60's Muscle Dials - Select
Polished Stainless Steel for that Traditional Muscle Car Look (default)
or sport it up a bit with Black or Silver Anodized Aluminum
Please select your fuel level option below - defaults to pre 1985
Ford 73-10 Ohm
Please select if you need a signal generator - defaults to NONE
Speedometer will work with any OEM or aftermarket speed sensor or electronic
module that meets the following conditions:
Pulse range generated proportional to the vehicle speed Signal with minimum 3V peak to peak signal - typical for 3-wire hall
effect and 2 wire vehicle speed sensor outputs
output of 4,000 to 200,000 pulses per mile (most senders are 16,000 ppm)
If you currently have a mechanical speedometer (cable driven) you will need a
hall effect sender. See the Available Options Below to add the
correct hall effect
sender to your order. The hall effect sender installs on your current
transmission cable take off location. The signal from the hall effect sender
(12V Square Wave signal) drives the electric speedometer. Available Options:
Bezel Ring Options: Polished Stainless Steel Silver Anodized Aluminum Black Anodized Aluminum
Fuel Level Compatibility: 73-10 Ohm (Most Pre '85 Ford and Mopar) 0-30 ohm (Most GM Vehicles Before 1965) 0-90 ohm (Most GM Vehicles after 1965) 20-150 ohm (Most FORD vehicles after 1985) 240-33 ohm Generic Aftermarket
Speedometer Sender Options: None Ford, Hall Effect, 16 Pulse (+$44.95) GM, Hall Effect, 16 Pulse (+$44.95)